Hey there, not sure if it's the correct category, but I believe this is an electronic issue: I have two buttons hooked up to pin D3 and D4 of my Wemos D1 mini clone (these are the pull-up pins) that connect to GND when closed. Closing a button is supposed to change the direction of a motor through an ESC hooked to pin D0. I measured the voltage over D3 und D4 and GND and they're both nicely pulled up to 3.3V. However, the Motor is continuously changing directions (not very often but every 3-10
Improved Arduino Rotary Encoder Reading : 4 Steps (with Pictures) - Instructables
Wemos D1 mini/ ESP8266 have problem in serial monitor output - IDE 1.x - Arduino Forum
Wemos D1 clone: digitalRead is unreliable - General Electronics - Arduino Forum
WS2812b work with NodeMCU, but not with Wemos D1 mini - Project Guidance - Arduino Forum
Wemos D1 R2 duplicate pins - Programming Questions - Arduino Forum
Strange problem with wemos d1 - Project Guidance - Arduino Forum
How to get the best out of this forum - IDE 1.x - Arduino Forum
ESP32 CAM to Arduino Communication - Programming Questions - Arduino Forum
RGB LED strip MySensors Forum
Wemos D1 R2 not working on PCB - Home Automation - Arduino Forum
110v-230v AC to Mysensors PCB board
WEMOS D1 other pins outputting power when they are not supposed to - Project Guidance - Arduino Forum
Wemos D1 pins - #23 by system - IDE 1.x - Arduino Forum